Mr226

Forum Replies Created

Viewing 5 replies - 1 through 5 (of 5 total)
  • Replies
  • Mr226
    Member
    Quote Originally Posted by panntasticView
    I used to fall for this all the time when doing quads and glutes using 25 gauge 1" then I switched up to 23g 1 1/4" and all was sweet

    Just a though op

    So short inj time or fast? And I could try 1 1/4 or 1 1/2 needles too. 23 or 25g on quads.

    Also, anyone know how long I need to be on here before my Avatar pic shows up?

    Mr226
    Member
    Quote Originally Posted by drabView
    Damnnn 20 sec on a 25g needle? How can u push oil thru that fast? Better slow it down

    Probably why heating it didn’t help, lol. Only allowed it to push faster… Dammit, lesson learned.

    Mr226
    Member
    Quote Originally Posted by DomusView
    Gross. Dont heat vile

    Just inject slow and St07 on keeping a steady hand. The tip of the needle is like a blade, too much movement and you cause too many tears in the fibers and they will react. I prefer a 23g 1" syringe. Pin at a rate of 1 minute per ML. I even stop half way and pause for a few seconds.

    Yeah, I bet that’s my problem. I don’t shake, but I don’t take 60 seconds, more like 20. I will move much slower next time…

    Mr226
    Member
    I was told this was legit gear, ordered from an expensive, quality source,somaybe a high alcohol content. But that’s just an opinion.

    I feel like a beast in the gym though! Wouldn’t trade these gains for anything! 191 and 10% BF to 208 and 12% BF in 6 weeks! Pumps are insane, but i have spent a few years building my base, so I fully expected my first test cycle to be great. I just smashed a bi/tri arm workout tonight,it was wild the pumps I had.

    Only sides so far are high BP (hypertension) , but thats cause im a stim junkie and i need my caffeine,trying to minimize it and Im getting better.

    Mr226
    Member
    Quote Originally Posted by valkyrieView
    If there was one day that didn’t hurt that points to injection technique problems. To be sure try a half or quarter shot sub probably will be completely painless.

    So if I have decent quads with about 12% BF, I should try injecting slower?

    And I’m with ya’ll, technique makes the most sense. I believe I may need to slow down the actual injection. I’m aspirating and swabbing and heating the vile, but I guess it will just come with experience.

Viewing 5 replies - 1 through 5 (of 5 total)